ATCPro Forums Homepage
Forum Home Forum Home > ATC Pro Forums > General Discussion
  New Posts New Posts RSS Feed - Arrivals and DynamicRouteImpl.txt File
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Arrivals and DynamicRouteImpl.txt File

 Post Reply Post Reply
Author
Message
bill3810 View Drop Down
Member
Member


Joined: 13 Jun 2016
Status: Offline
Points: 99
Post Options Post Options   Thanks (0) Thanks(0)   Quote bill3810 Quote  Post ReplyReply Direct Link To This Post Topic: Arrivals and DynamicRouteImpl.txt File
    Posted: 12 Jan 2019 at 9:22am
I decided to open a new topic on this because I was hijacking the other thread.

In Atlanta with East Flow on the Dirty 2 when descending on the Dirty 2 from the NE most of the traffic will go to the North Side i.e. 8L.  However having flown to Atlanta many timesmyself sometimes the North side will get busy and you will be assigned the south side, plink in the runway and you follow the appropriate routing.

Problem is you can't do that with ATC Pro.  I think it's associated with the DynamicRouteImpl.txt file.  If the first entry is this.

dirty [two] [ arrival ] [runway] [[zero] eight left] [transition] {out="DIRTY2.MOL.08L.1";}

Then that's where everyone goes, the only way to get them to go to the south side is to put this line as the first entry.

dirty [two] [ arrival ] [runway] [[zero] niner right] [transition] {out="DIRTY2.MOL.09R.1";}

Unfortunately then no one goes to the North side even when assigned this as their runway.

Even worse when you hand them off to the controller 1H on the South Side he hands them back after turning them back to the NW for 08L, so not sure here.

Any of you tinkering experts figured this one out??


Edited by bill3810 - 12 Jan 2019 at 9:34am
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.031 seconds.